Valve and Pump Material Equivalents
EN to ASTM equivalents for the materials most often named on valve and pump datasheets: cast carbon steel, cast stainless steel, grey iron and ductile iron. Use this table to read a European material grade and find its nearest ASTM counterpart.
“Equivalent” is approximate. The EN and ASTM grades in this table do not have fully identical chemistry and mechanical requirements, so one cannot simply be swapped for the other — any substitution needs engineering confirmation against the governing standard and the manufacturer’s data.
GB equivalents are being added: the GB column below is intentionally blank (shown as “—”) until each grade has been verified against a GB standard. No GB grades are listed here yet.
| EN number | EN grade | ASTM equivalent | GB equivalent | Type | Common use | Note |
|---|---|---|---|---|---|---|
| 1.0619 | GP240GH | A216 WCB | — | Cast carbon steel | General-purpose cast steel valves and pumps | — |
| 1.4308 | GX5CrNi19-10 | A351 CF8 | — | Cast stainless steel (304 type) | Corrosive service, food and chemical duty | — |
| 1.4408 | GX5CrNiMo19-11-2 | A351 CF8M | — | Cast stainless steel (316 type) | Chloride-bearing and chemical service | — |
| EN-JL1040 | EN-GJL-250 | A48 Class 40B (KSB); valve industry also uses A126 Class BSources disagree | — | Grey cast iron | Low-pressure water valves and pump casings | Sources disagree: KSB lists A48 Class 40B; valve-industry references commonly list A126 Class B. Both are shown. |
| EN-JS1030 | EN-GJS-400-15 | A536 60-40-18 (KSB); other sources list 65-45-12Sources disagree | — | Ductile iron | Water and wastewater valves, pump casings | Sources disagree on the ASTM grade (60-40-18 vs 65-45-12). Both are shown. |
| EN-JS1025 | EN-GJS-400-18-LT | A536 60-40-18 | — | Ductile iron (low temperature) | Low-temperature water service | — |
| 1.4301 | X5CrNi18-10 | 304 | — | Stainless steel | General stainless trim and shafts | Common correspondence, not separately checked. |
| 1.4401 | X5CrNiMo17-12-2 | 316 | — | Stainless steel | Corrosive service trim and shafts | Common correspondence, not separately checked. |
| 1.4404 | X2CrNiMo17-12-2 | 316L | — | Stainless steel | Welded stainless components | Common correspondence, not separately checked. |
Two rows are marked “Sources disagree”: EN-GJL-250 and EN-GJS-400-15. For those, the table shows both published ASTM equivalents with their sources instead of picking one side. The three wrought stainless rows (304, 316, 316L) are common correspondences that were not separately checked against a source table, and are labelled as such.
Sources
- KSB, "Cast materials" data table
- William Cook, materials group comparison table
- Sulzer, cast materials handbook
- VAG, material notes
Related pages
- Flange compatibility checker — check whether an EN flange and an ASME flange will bolt together.
- PN to Class conversion — the nominal correspondence between PN ratings and ASME Classes.
Material equivalents are approximate: chemistry and mechanical requirements differ between the EN and ASTM grades, and substitution needs engineering confirmation. For preliminary estimates only. Verify against manufacturer data and the governing standard before purchase or installation.